![]() ![]() The Dolby conference phone will begin to boot up (takes a few minutes) and will search for nearby Highfive devices.Connect the Dolby conference phone to your PoE wall jack or switch.There is no support for 1000 Mbps or higher with the current DCP hardware, though it should work fine at 100 Mbps on higher bitrate networks. The DCP connection to the LAN is 100 Mbps max.The Dolby device needs to be within 25 feet (line-of-sight) of the Highfive device.The Highfive device needs to be fully set up and on the “Get started at…” home page prior to setting up the Dolby device.The PoE jack needs to be on the same subnet and VLAN (if applicable) as the Highfive device you wish to connect it to.If you plan on connecting any other PoE devices in the future, it is a good idea to get a switch that can support the increased wattage requirements. The only requirements we have are to make sure it has 802.3af compatibility and can provide 13W of power. Purchase a switch with PoE as a feature.This device connects between your Dolby conference phone and currently existing ethernet port, supplying the connection with power. Contact your Highfive Account Executive to purchase a PoE injector.The Dolby conference phone requires a Power-over-Ethernet (“PoE”) port to provide both power and network connectivity to the device.Both devices establish and maintain a P2P connection over your Local Area Network (LAN). This article will show you how to connect your Dolby conference phone (DCP) to your Highfive device. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |